ABS system components for rear axle (all-wheel drive), removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
1 - ABS speed sensor
- Checked by On Board Diagnostic (OBD)
- Before inserting sensor, clean fitting hole inner surface and coat with lubricant paste G 000 650
- All-wheel drive. Refer to ABS system components for rear axle (all-wheel drive), removing and installing
2 - Hex socket head bolt, 8 Nm (71 in. lb)
3 - Trailing arm
4 - Splash plate
5 - Hex bolt, 10 Nm (7.37 in. lb)
6 - Brake disc
7 - Phillips-head screw
8 - Wheel hub with rotor
- Press out and in
Refer to REAR WHEEL BEARING, PRESSING OUT AND IN WITH TRAILING ARM INSTALLED
9 - Circlip
10 - Wheeling bearing
- Replace each time after removing
- Pressing out and in
Refer to REAR WHEEL BEARING, PRESSING OUT AND IN WITH TRAILING ARM INSTALLED