Transmission Control Module J217, Replacing: Installation
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in the reverse order of removal. note the following:
- Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code the Transmission Control Module (TCM) J217.
- Erase the DTC memory. Refer to DIAGNOSTIC MODE 04: RESET/DELETE DIAGNOSTIC DATA .
- Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to READINESS CODE, GENERATING .
- End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
- Replace the Motronic Engine Control Module (ECM) J220. Refer to REPLACING ENGINE CONTROL MODULE (ECM) .
- Assembly is performed in the reverse of the removal.