Support rails VW 457/1, modifying: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is performed in the reverse order of removal. Note the following:

When installing the torque converter, ensure that both drive pins engage in the ATF pump inner wheel recesses.

Before installing, ensure that dowel sleeves are correctly located.
Before installing transmission ensure that torque converter seats correctly in transmission. Refer to Torque converter, installing .
When installing transmission, observe torque converter contact impression on drive plate.
Replace selector cable anchorage locking washer.

Check selector lever cable adjustment, adjust if necessary. Refer to Selector lever cable, checking and adjusting .
Check and top up ATF level. Refer to ATF level, checking and topping up .
Perform On Board Diagnostic (OBD) and initiate basic setting: