Pressing clutch -K1- onto -K3-

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Turbine Shaft Recess

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Clipping Axial Needle Bearing With Washer To 3rd And 4th Gear Clutch -K3-

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Preparing Clutch -K1- & -K3- For Pressing Using Special Tools VW412, VW415A, VW418A & VW402

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 4: Aligning VW 418 A Centrally Onto Surface For Axial Needle Bearing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Before pressing on, align VW 418 A centrally onto surface for axial needle bearing (Fig 4 shows -K3- from below).
Press clutch -K1- on carefully until stop is perceptible.

NOTE: Do not exert further pressure onto clutches!