Table of shims
WARNING: This page is about a different variant/trim than selected.
| Indicator reading (mm) | Shims (mm) |
| 1.26... 1.35 1.36... 1.45 1.46... 1.55 |
1.0 1.1 1.2 |
| 1.56... 1.65 1.66... 1.75 1.76... 1.85 |
1.3 1.4 1.5 |
| 1.86... 1.95 1.96... 2.05 2.06... 2.15 |
1.6 1.7 1.8 |
| 2.16... 2.25 2.26... 2.35 2.36... 2.45 |
1.9 2.0 2.1 |
| 2.46... 2.55 2.56... 2.65 2.66... 2.75 |
2.2 2.3 2.4 |
| 2.76... 2.85 2.86... 2.95 2.96... 3.05 |
2.5 2.6 2.7 |
| 3.06... 3.15 3.16... 3.25 |
2.8 2.9 |
Example:
Measured value 2.00 mm =
Insert 1.7 mm thick shim.
- Remove small input shaft bolt.
- Insert correct shim -3- on small input shaft (arrow).
- Tighten small input shaft bolt -1- with washer -2-.
Tightening torque 30 Nm.
- Perform planet carrier check measurement. Refer to Planet carrier check measurement .