Vehicles with manual transmission
WARNING: This page is about a different variant/trim than selected.
Vehicles with automatic transmission.
- Remove wiper arms and cowl panel: →92 WINDSHIELD WIPER & WASHER SYSTEM
- Release Engine Control Module (ECM) J248 connector and remove.
- Connect test box V.A.G 1598/22 (through my 1999) or test box V.A.G 1598/31 (from my 2000) to control module wiring harness.
- Check CAN-Bus wiring with terminal resistor in ABS Control Module:
- Measure resistance between test box sockets 68 + 75:
Specification: 115 to 135 Ω
If resistance value is within specified range.