Vehicles with automatic transmission
WARNING: This page is about a different variant/trim than selected.
- Remove wiper arms and cowl panel: →92 WINDSHIELD WIPER & WASHER SYSTEM
- Remove connector - arrow - from Transmission Control Module (TCM) J217.
- Connect test box V.A.G 1598/18 to Transmission Control Module (TCM) J217 wiring harness - 1 - and lock connector - 2 -.
- Check CAN-Bus wiring with terminal resistors in Engine and ABS Control Modules.
- Measure resistance between test box sockets 3 + 25:
Specification: 55 to 75 Ω