Display group 004 at idle with engine warm, coolant temperature not below 80 ° C (176 ° F)
WARNING: This page is about a different variant/trim than selected.
| Display group 004 -Start of injection- | ||||||
| Read measuring value block 4 | → | Indicated on display | ||||
| xxxx RPM | xx.x ° B/ATDC | xx.x ° B/ATDC | xxx % | |||
| 1 | 2 | 3 | 4 | Display zones | Specification | Evaluation |
| Cold Start Injector duty cycle | 3...80% | --- | ||||
| Start of injection (actual) | 2 ° ATDC...3 ° BTDC | |||||
| Start of injection (specified) | 2 ° ATDC...3 ° BTDC | |||||
| Engine speed (idle) | 870...950 RPM | --- | ||||