Display group 60 (Speed regulation) Adaptation EPC system * See note

WARNING: This page is about a different variant/trim than selected.

Readiness code

Display group 60 (Speed regulation) Adaptation EPC system * See note
Ignition on, engine not running
Control unit in mode 04 basic setting
Read Measuring Value Block 60			→	Indicated on display
xx%	xx%	x	Text
1	2	3	4	Display zones	Specification	Evaluation
				Adaptation condition (ADP runs, ADP OK or ADP ERROR)	ADP OK	---
			Learning step counter		0 to 8	---
		Throttle Drive Angle Sensor 2 (for Electronic Power Control (EPC)) G188			97 to 3%	---
	Throttle Drive Angle Sensor 1 (for Electronic Power Control (EPC)) G187				3 to 93%	---

* Adapting engine control module to throttle valve control module → Engine control module, adapting to throttle valve control module .

NOTE:

For display zone 60:
Matching the throttle valve control module is performed with ignition switched on.
Engine control module is adapted to throttle valve control module when selecting display group 60 under function 04 "Basic setting". This adaptation must always be carried out when another throttle valve control module (or another complete engine) or another engine control module is installed.
The counter counts up to 8 in display zone 3 during the adaptation.