Secondary air system components, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The components labeled with * are checked by On Board Diagnostic (OBD): Refer to 01 ON BOARD DIAGNOSTIC (OBD)
- The components labeled with ** are checked by output diagnostic test mode: Refer to 01 ON BOARD DIAGNOSTIC (OBD)
- Secondary Air Injection (AIR) Pump Relay J299 **Secondary Air Injection (AIR) Pump Relay under Secondary air system components, removing and installing
1 - Combination valve
- Checking, refer to Combination valve, checking
- Removing and installing, refer to Combination valve, removing and installing
2 - 10 Nm
3 - O-ring
- Always replace
4 - Air duct
- In cylinder head
5 - Secondary Air Injection (AIR) Solenoid Valve N112 */**
6 - To fuel pressure regulator
7 - To intake manifold
8 - Connector
- Black, 2-way
- For secondary air injection solenoid valve
9 - Check valve
- White terminal points to Secondary Air Injection (AIR) Solenoid Valve N112
10 - To vacuum tank
- Fastened to front oil pan
11 - Intake Manifold Tuning (IMT) Valve N156
- Clipped onto bracket of oil filter casing
12 - Bracket
13 - 25 Nm
14 - 10 Nm
15 - Bracket
- For Secondary Air Injection (AIR) Pump Motor V101
- For Secondary Air Injection (AIR) Solenoid Valve N112
16 - To vacuum adjusting screw for intake manifold change-over
17 - Connector
- Black, 2-way
- For Intake Manifold Tuning (IMT) Valve N156
18 - Connector
- Black, 2-way
- For Secondary Air Injection (AIR) Pump Motor V101
19 - Secondary Air Injection (AIR) Pump Motor V101 **
- On the front engine block
- For removing and installing, put lock carrier into service position: Refer to LOCK CARRIER SERVICE POSITION
- Loosen air conditioning compressor from its bracket, refer to A/C COMPRESSOR AND BRACKET
20 - O-ring
- Replace if damaged
21 - Discharge hose
- Make sure of tight fit
22 - To top of air filter
23 - Intake hose
- Make sure of tight fit
24 - 5 Nm
25 - Screw connections
- For combination valve