Exhaust manifold/ front exhaust pipe/catalytic converter with attachments
WARNING: This page is about a different variant/trim than selected.
1 - Seal
- Always replace
2 - 25 Nm
3 - Heat shield
4 - Exhaust manifold
- Two-piece
5 - Hanger shackle
6 - 6-pin connector
- Black; for oxygen sensor and oxygen sensor heater
7 - Heated Oxygen Sensor (HO2S) G39 , 50 Nm
- Grease only threads with G 052 112 A3 . It must not touch slot on sensor body
- Use wrenches 3337 to remove/install
- Checking: Refer to 24 MULTIPORT FUEL INJECTION (MFI)
8 - 4-pin connector
- Black; for oxygen sensor and oxygen sensor heater
9 - Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) G130 , 50 Nm
- In catalytic converter
- Grease only threads with G 052 112 A3 . It must not touch slot on sensor body
- Remove/install with wrenches 3337
- Checking: Refer to 24 MULTIPORT FUEL INJECTION (MFI)
10 - Front exhaust pipe with catalytic converter
11 - To resonator
12 - 10 Nm
13 - 15 Nm
14 - Heat shield
15 - 40 Nm
16 - Gasket for front exhaust pipe
- Always replace