Evaporative emissions system, diagram
WARNING: This page is about a different variant/trim than selected.
1 - Fuel filler door module
2 - Fuel tank
3 - Fuel delivery unit
4 - Upper intake manifold
5 - Pressure regulator
6 - Supply rail with injectors
7 - Fuel filter
- Install position: - arrow - indicates direction of flow
8 - Evaporative emission (EVAP) canister purge regulator valve N80
- In engine compartment on right
- Installed position: - arrow - indicates direction of flow
- Check via Output DTM: Refer to 01 ON BOARD DIAGNOSTIC (OBD)
- Checking operation, refer to Evaporative emission (EVAP) canister purge regulator valve N80 , checking
9 - Test socket
10 - Gravity/overflow valve
11 - Pressure retention valve
12 - Change-over valve
13 - EVAP canister
- In right rear wheel housing underneath liner
- Fastened to body
14 - Leak Detection Pump (LDP) V144
- On EVAP canister
15 - Air filter for leak detection pump