Main radiator
WARNING: This page is about a different variant/trim than selected.
Auxiliary radiator
1 - Radiator
- Removing and installing, refer to Radiator, removing and installing
- After replacement, refill completely with new coolant
2 - O-Ring
- Replace if damaged
3 - Upper coolant hose
- Fastened to radiator with rapid action hose coupling
- Ensure tight fit
- Coolant hoses, connection diagram, refer to Coolant hoses, connection diagram
4 - Air scoop
5 - 10 Nm
6 - Coolant Fan V7
7 - Fan bracket
8 - Retaining clamp
- Check for tight fit
9 - Connector
10 - Right coolant fan V35
11 - Bracket
- For fan connector
12 - Lower coolant hose
- Fastened to radiator with rapid action hose coupling
- Make sure tight fit
- Coolant hoses, connection diagram, refer to Coolant hoses, connection diagram
13 - O-Ring
- Always replace
14 - Coolant Fan Control (FC) Thermal Switch F18 , 35 Nm
- For electric fan
Switching temperatures, 1st stage:
- On: 92-97 ° C
- Off: 84-91 ° C
Switching temperatures, 2nd stage:
- On: 99-105 ° C
- Off: 91-98 ° C
15 - Bracket
- For radiator
- Observe installed position
16 - 15 Nm