Work sequence

WARNING: This page is about a different variant/trim than selected.

Disconnect electrical connector from After-Run Coolant pump V51.
Connect contacts on After-Run Coolant pump V51 with battery using auxiliary cables from Auxiliary measuring tool set VAG 1594 A.

Fig 1: Contacts Of After-Run Coolant Pump V51 Connected To Battery

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pump should start

If the pump does not start:

If the After-Run Coolant pump V51 starts:

Fig 2: Voltage Tester Connected To Disconnected Connector Of After-Run Coolant Pump V51

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect Voltage tester VAG 1527 B to disconnected connector of After-Run Coolant pump V51 using auxiliary cables from Auxiliary measuring tool set VAG 1594 A.

LED should illuminate

NOTE:

This test must be conducted within 10 minutes of the time that the ignition was turned off.

If the LED does not illuminate:

Using wiring diagram find and repair open circuit: Refer to Electrical Wiring Diagrams, Troubleshooting and Component Locations