Cylinder head cover, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
The installation takes place in the reverse order.
NOTE:
- If damaged or leaking, replace cylinder head cover.
- First, screw the upper intake manifold to the lower intake manifold, then tighten both manifold support screws.
- Make sure the fuel hoses are firmly connected.
- If necessary, refill coolant, refer to Coolant, draining and filling .
- Check DTC memory. Refer to 01 ON BOARD DIAGNOSTIC (OBD)
- Adjust basic settings. Refer to 24 MULTIPORT FUEL INJECTION (MFI)
- Check readiness code. Refer to 01 ON BOARD DIAGNOSTIC (OBD)
- If Diagnostic Trouble Code (DTC) memory was erased or engine control module was disconnected from positive continuous voltage feed, regenerate readiness code: Refer to 01 ON BOARD DIAGNOSTIC (OBD)