Secondary air injection (AIR) system components, assembly overview: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Components marked with * are checked via On Board Diagnostic (OBD).
- Components marked with ** are checked via output Diagnostic Test Mode (DTM).
- Secondary Air Injection (AIR) Pump Relay J299 **Secondary Air Injection (AIR) Pump Relay under Secondary air injection (AIR) system components, assembly overview
1 - Combi-valve
- Checking, refer to Combi-valve, checking
2 - Gasket
- Replace
3 - Connecting piece
- Secured to cylinder head
4 - Bracket
5 - 10 Nm
6 - Bracket
- Fastened to intake manifold
7 - To vacuum reservoir
8 - Vacuum hose
9 - Connector
- 2-pin
10 - Secondary Air Injection (AIR) Solenoid Valve N112 */**
- Tightened to 6 Nm on bracket
- Resistance: 21 to 24 Ω
- Checking, refer to Secondary Air Injection (AIR) Solenoid Valve N112 , checking
11 - Intake tube
- For secondary air injection pump
- Ensure seated tightly
- Press together at front to release
12 - To air filter
13 - O-ring
- Replace
14 - Connector
- 2-pin
- For Secondary Air Injection (AIR) pump motor V101
15 - 10 Nm
16 - Secondary Air Injection (AIR) Pump Motor V101
- Function, checking refer to Secondary Air Injection (AIR) Pump Motor V101 , checking
17 - 10 Nm
18 - Pressure hose
- Ensure seated tightly
- Press together at front to release
19 - 10 Nm
20 - 10 Nm
21 - Gasket
- Replace