EVAP canister system, assembly overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Components marked with * are checked via On Board Diagnostic (OBD).
- Components marked with ** are checked via output Diagnostic Test Mode.
1 - From Evaporative Emission (EVAP) Canister Purge Regulator Valve N80 */**
2 - Seal
- Replace if damaged
3 - Vent line
4 - Connection piece
5 - Connector
- 3-pin
6 - Vacuum line
7 - Leak Detection Pump (LDP) V144 */**
- Under wheel housing liner in right rear wheel housing
- Checking refer to Leak Detection Pump (LDP), checking
8 - Connecting hose
- Pressure side
9 - 3 Nm
10 - Air filter for Leak detection pump (LDP) V144
11 - Connecting hose
- Suction side
12 - Bracket
13 - 10 Nm
14 - EVAP canister
- Under wheel housing liner in right rear wheel housing