Valve dimensions
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Valves must not be refaced. Only lapping is permitted.
| Dimension | Intake valve | Exhaust valve | |
| Dia. a | mm | 26.9 | 29.9 |
| Dia. b | mm | 5.963 | 5.943 |
| c | mm | 104.84 to 105.34 | 103.64 to 104.14 |
| α | ∠ ° | 45 | 45 |
NOTE:
- Worn sodium-filled exhaust valves must not be scrapped without first being properly treated. The valves must be cut at the middle of the shaft using a metal saw. While doing this, do not come into contact with water. At the very most, throw 10 of the prepared valves into a bucket filled with water. Then, move quickly away, because a sudden chemical reaction will occur during which the sodium is burnt away. The treated parts may then be discarded through conventional disposal channels.