A - Toothed belt completely removed

If toothed belt was only removed from camshaft gear B - Toothed belt only removed from camshaft gear 

Conditions 

• The pistons must not be positioned at TDC.

Work procedure 

Fig 1: Marking On Camshaft Gear Aligned With Marking On Cylinder Head Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Align marking on camshaft gear with marking on cylinder head cover.
• Place toothed belt onto crankshaft sprocket (observe direction of rotation).
• Install engine bracket on cylinder block. Torque specification 45 Nm

• Install toothed belt cover - lower part. (Insert bolts with Locking Compound D 000 600 A2.) (Part numbers are for reference only. Always check with your Parts Department for the latest part number information). Torque specification: 10 Nm
• Using a bolt, secure vibration damper/belt pulley (watch locating point).

Fig 2: Identifying Vibration Damper At TDC No. 1 Cylinder

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Turn crankshaft to set cylinder 1 at TDC.
• Position toothed belt on coolant pump, tensioning roller and camshaft gear.
• Tension toothed belt.