Installing drive plate.

Fig 1: Identifying Drive Plate And Appropriate Shims

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Set drive plate in place, using washer with notches - 1  -.
• Insert new bolts - 3  - and tighten to 30 Nm.

Fig 2: Measuring Through Hole In Drive Plate To The Milled Surface Of The Cylinder Block

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Check dimension - a  - an three points and calculate mean value. Specified value: 19.5 to 21.1 mm

If specification is not obtained:

Fig 3: Identifying Drive Plate And Appropriate Shims

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove drive plate again and use shim - 2  -. Tighten bolts again to 30 Nm.
• Tighten bolt to 60 Nm and turn an additional 90 ° (1/4 turn, additional turn may occur in several stages).