Muffler with mountings: Notes

Muffler with mounts for vehicles with all-wheel drive. Refer to Muffler with mounts for vehicles with all-wheel drive  .

1 - 40 Nm 

2 - From front exhaust pipe 

3 - Double clamp 

• Note installation position Installation position of double clamp  under Installation position of double clamp 

4 - 25 Nm 

5 - Suspended mount 

• Note installation position Installed location of mountings  under Muffler with mountings 

6 - Suspended mount 

• With retaining ring

7 - Bracket 

8 - Suspended mount 

9 - Rear muffler 

• Installing muffler free of tension Installing muffler free of tension 

10 - Separating point 

• For repairs
• Marked by three depressions around circumference of exhaust pipe
• At factory, exhaust pipe and rear mufflers are installed as a single component. Replacement exhaust pipe and rear muffler are supplied separately, with replacement double clamp for connecting joint.
• Cut through exhaust pipe with e.g. body repair saw V.A.G 1523A at right angles at separating point Separation point on exhaust pipe 

11 - 20 Nm 

12 - Tunnel bridge