Work sequence
WARNING: This page is about a different variant/trim than selected.
- Disconnect fuel shut-off valve connector at injection pump.
- Separate quantity adjuster connection from injection pump.
- Remove all glow plugs using hinged socket 3220.
- Install adapter V.A.G 1381/12 in place of glow plugs.
- Check compression pressure using compression tester V.A.G 1763.
NOTE:
- Using tester. Refer to Operating instructions.
- Operate starter until tester shows no further pressure increase.
Compression pressure:
New: 25 to 31 bar; Wear limit: 19 bar pressure
Permissible difference between all cylinders: 5 bar
- Install glow plugs using hinged socket 3220 tightening torque: 15 Nm.
- Check DTC Memory: Refer to 01 ON BOARD DIAGNOSTIC (OBD) from M.Y. 99-01 or 01 ON BOARD DIAGNOSTIC (OBD) from M.Y. 2002 and on
NOTE:
- DTCs will be stored because the Diesel injection pump harness connector has been disconnected. Check and erase the DTC memory.