Evaluation test-ID 01:
WARNING: This page is about a different variant/trim than selected.
EVALUATION TEST-ID 01: TANK LEAK TEST (ENGINE CODE AVH, AZG)
| Tank leak test | Specified value: |
|---|---|
|
Test function active |
NOTE:
- If the accelerator pedal is depressed during the test, the test will be aborted.
- To repeat the tank leak test, switch ignition off and start engine again and let run at idle for at least 15 minutes.
If specified value is obtained:
- End diagnosis and switch ignition off.
If specified value is not obtained:
- EVAP canister system, checking for proper seal. See EVAPORATIVE EMISSIONS (EVAP) SYSTEM .
- Leak Detection Pump (LDP) -V144-, checking. See EVAP SYSTEM, CHECKING USING KLI 9210 TESTER .