Transmission Fluid Temperature Sensor G93 With Wiring Harness, Removing And Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Fluid Temperature Sensor G93 cannot be separated from the wiring harness.

Removing

Remove valve body, refer to Valve body, removing and installing .
Remove torque converter housing, refer to Transmission, disassembling and assembling .
Remove bearing and differential cage.
Remove ATF screen.

Fig 1: Disconnecting Connectors Off Sensors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connectors off sensors - 1 - and - 2 -.
Remove retainer - 4 - arrow -.
Remove Transmission Fluid Temperature Sensor G93 - 3 -.
Turn transmission.
Remove cover, refer to Transmission, disassembling and assembling .

Fig 2: Attention (Do Not Turn Back Transmission Before Cover Is Reinstalled)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Do not turn back transmission before cover is reinstalled. Otherwise, clutch "K2/K3" and other components will fall out.

Disconnect connector off Transmission Input Speed (RPM) Sensor G182 - 1 -.

Fig 3: Removing Sensor Bolts And Remove

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove sensor bolts and remove.
Remove Transmission Fluid Temperature Sensor G93 with wiring harness downwards.

Installing

Guide wire for sensor Transmission Input Speed (RPM) Sensor G182 from beneath through transmission housing.

Fig 4: Pushing Connector Onto Sensor And Install Sensor

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push connector onto sensor and install sensor. Tighten bolt to 8 Nm.
Install cover, refer to Install cover .
Turn transmission.
Install Transmission Fluid Temperature Sensor G93 and tighten bolts to 8 Nm.
Connect connectors for Vehicle Speed Sensor (VSS) G68 and Intermediate Shaft Speed Sensor G265.
Install wiring harness retainer and tighten bolt to 8 Nm.
Guide wiring into valve body housing.
Install ATF strainer.

Install remaining parts, refer to Transmission, assembling .