Shift Lock Solenoid N110, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Connector & Shift Lock Solenoid N110

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push connector - arrow - onto Shift Lock Solenoid N110.

Fig 2: Hook In Solenoid For Locking Pawl

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Hook in solenoid for locking pawl - arrow B -.
Clip Shift Lock Solenoid N110 into retainer - arrows A -.
Bolt cover with glued-on seal to mounting bracket. When doing this, check position of seal.

Fig 3: Identifying Selector Mechanism Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tighten nuts - arrows A - to 10 Nm.
Then tighten both bolts - arrows B - to 25 Nm.
Install front and middle heat shields for tunnel.
Hook selector lever cable into retainer on front heat shield.
Reassemble exhaust system. → - Repair Group 26
Connect earth strap to battery.
Check selector mechanism. Refer to Selector mechanism, checking .
Enter radio code. Refer to 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER .