Installing ATF Cooler

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in reverse order of removal. Note the following:

Replace O-rings of ATF cooler.

Fig 1: When Installing ATF Cooler , Insert Lug Into Recess In Transmission Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

When installing ATF cooler - 1 - , insert lug - arrow B - into recess in transmission housing.
Tighten bolt - arrow A -.
Finally, check ATF level and top off. Refer to ATF level, checking and topping off .