Operating cables, assembly overview: Notes

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Lubricate bearing areas and slide surfaces with grease G 000 450 02.

Fig 1: Selector Cables Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Shift lever cable

Installed position → Installed position of components at transmission

2 - Selector cable

Installed position → Installed position of components at transmission

3 - Locking washer

Always replace

4 - Locking washer

When removing, do not damage cables
Always replace

5 - Shift mechanism housing

6 - Hex bolt, 25 Nm

For mounting bracket

7 - Mounting bracket

8 - Grommet

For mounting bracket to transmission

9 - Spacer piece

10 - Cable locking mechanism

For selector cable on actuator lever
With continuous hole, as of 01.01
Not necessary to replace
Secured by a locking washer

Allocation: Allocation of cable locking mechanisms

11 - Actuator lever

Installed position: Installation position of transmission shift lever/actuator lever
Adjust shift mechanism after installing → Shift mechanism, adjusting in transmissions with lock bolts (up to transmission manufacture date 180503)

12 - Bushing

13 - Locking washer

14 - Shoe

15 - Transmission shift lever

With balance weight
Insert so that master spline aligns with selector shaft
Adjust shift mechanism after installing → Shift mechanism, adjusting in transmissions with lock bolts (up to transmission manufacture date 180503)
Installed position: Installation position of transmission shift lever/actuator lever

16 - Self-locking hex nut, 20 Nm

Always replace

17 - Cable locking mechanism

For shift cable on transmission shift lever
With continuous hole, as of 01.01
Not necessary to replace
Secured by a locking washer

Allocation: Allocation of cable locking mechanisms