All-Wheel Drive Control Module -J492- , removing and installing: Installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, note the following:

Fig 1: Identifying O-Rings

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If installed, replace O-rings - A - and - B -.

If a seal is installed , replace it.

Tighten bolts to tightening torque.
Check oil level in Haldex clutch → Oil level in Haldex clutch, checking and changing .