Pedal Cluster Assembly, Overview
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Bulkhead
- With support and clutch master cylinder housing
2 - Gasket
- Always replace
3 - Support
- For clutch pedal housing
4 - Bolt
5 - Support
- For accelerator and brake pedal housing
6 - Hex nut, self-locking 25 Nm
- Always replace
7 - Connecting plate
8 - Hex nut, self-locking, 25 Nm
- Always replace
9 - Mounting bushing
10 - Mounting pin
11 - Clutch pedal
- Removing and installing. Refer to Clutch pedal, removing and installing
12 - Bearing bracket
- Removing and installing. Refer to Hydraulic components, assembly overview , item 4
13 - Hex nut, self-locking, 25 Nm
- Always replace
14 - Clutch master cylinder
- Removing and installing. Refer to Clutch master cylinder, removing and installing
15 - Circulation hose
16 - Over-center spring
- Removing and installing. Refer to Over-center spring, removing and installing
17 - Over-center spring seating
- Install in mounting bracket
- To replace, remove and install clutch master cylinder. Refer to Clutch master cylinder, removing and installing
18 - Clutch vacuum vent valve switch -F36-
- When removing and installing switch, push clutch pedal down as far as possible by hand.
- Before removing clutch pedal, remove switch with left turn of 45and pull out from support through mounting hole.
- Insert switch in mounting hole and secure with right turn of 45.
19 - Stop flange
- For clutch pedal
- Installed position. Refer to Installing
20 - Hex nut, self- locking 25 Nm
- Always replace