Injectors, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Always replace heat insulating seal between cylinder head and injectors.
- Insert injector.
- Check mounting is seated correctly in cylinder head.
- Install retainer.
Tightening torques:
Injection lines = 25 Nm
Retainer screw = 20 Nm
- Check DTC memory and, if necessary, repair any malfunctions and then erase → Diagnostic Trouble Code (DTC) memory, checking and erasing .
- Read readiness code → Reading readiness code .