Selectable functions, when using Scan Tools (ST) VAG1551 /1552 or VAS5051
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisites to select desired functions can be found in table below.
| Function | Prerequisite | |||
| VAG1551 /1552 or on VAS5051 | Engine stationary, ignition switched on | Engine running at idle | Vehicle being driven | |
| 01 | Check Engine Control Module version | yes | yes | yes |
| 02 | Check DTC memory | yes * See note | yes | yes |
| 03 | Output Diagnostic Test Mode | yes | yes | no |
| 04 | Basic setting | no | yes | no |
| 05 | Erase DTC memory | yes | yes | yes |
| 06 | End output | yes | yes | yes |
| 07 | Code Control Module | yes | no | no |
| 08 | Read Measuring Value Block | yes | yes | yes |
*Only with ignition on and engine not running.