Automatic test sequence
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
During test and assembly work DTCs can be recognized from other control modules like e.g. plug disconnected. Therefore, on completion DTC memory for all control modules must be check and erased, as follows:
- Press button 0 twice for address word "Automatic test sequence" and confirm entry with Q button. VAG1551 transmits all known address words one after another.
When a control module answers with its identification the number of stored DTCs appears on display or "No DTC recognized" appears.
Any DTCs stored will be displayed one after another and printed out. VAG1551 will transmit next address word.
Automatic test sequence has ended when the following is displayed:
| VAG ON BOARD DIAGNOSTIC HELP 1 - Rapid data transfer* |
| VAG ON BOARD DIAGNOSTIC HELP 2 - Blink code output* |
* Appears alternately
- Erase all DTC memory, then road test.
Observe all safety measures during test drive → Safety precautions .
- If the DTC was erased the readiness code must be generated again → Readiness code, setting .
- Check DTC memory for all control modules using "automatic test sequence".
If no DTC is stored:
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons 0 and 6 for "End output" and confirm with Q button.
- Switch ignition off.