Work sequence
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- With engine at idle connect Scan Tool (ST) VAG1551 / VAG1552 and select Engine Control Module (ECM) with "Address word" 01. → Scan Tool VAS5051 , connecting , Scan Tool VAG1551 , connecting.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons 0 and 8 for "Read Measured value block" and confirm with Q button.
Indicated on display:
| Read measured value block Enter display group number XXX |
NOTE:
- The display group number - 001 - is an example, to illustrate sequence.
- Press keys 0 , 0 and 1 for "Display group number -1-" and confirm entry with Q key.
Indicated on display: (1...4 = Display zones)
| Read measured value block 1 → 1 2 3 4 |
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press keys 0 and 6 for the "End output" function and confirm input with the Q key.
NOTE:
- To change to another display group proceed as follows:
| Display group | VAG1551 | VAG1552 |
| Higher | Press button 3 | Press ↑ button |
| Lower | Press button 1 | Press ↓ button |
| Skip | Press button C | Press button C |