Fuel tank, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse sequence ; note the following points:

Route breather and fuel hoses kink free.
Ensure tight fit of fuel hoses.
Do not interchange supply and return hose (return hose blue or blue markings, supply hose black).

NOTE:

After installing fuel gauge sender, check that the supply, return and breather pipes are still clipped onto the fuel tank.

Check DTC memory: → 01 ON BOARD DIAGNOSTIC (OBD)
Adapt (match) engine control module to throttle valve control module: → 24 MULTIPORT FUEL INJECTION (MFI)
Perform work sequence "Procedure after interrupting voltage supply" : → 24 MULTIPORT FUEL INJECTION (MFI)
Read readiness code: → 01 ON BOARD DIAGNOSTIC (OBD)

Generate readiness code again if DTC memory has been erased or engine control module separated from permanent positive supply: → 01 ON BOARD DIAGNOSTIC (OBD)