LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (2.8L - Engine Mechanical, Engine Code: BDF) >> 13 - Engine - Crankshaft, Cylinder Block >> Engine, disassembling and assembling >> Ribbed belt, removing and installing >> Installing ribbed belt

Installing ribbed belt

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Make sure, before installing ribbed belt, that all ancillary (alternator, air conditioning compressor, power steering pump) are secured tightly.
  • When installing the ribbed belt observe belt direction of rotation and that the belt is seated correctly in the belt pulleys.
Fig 1: Identifying Ribbed Belt Routing
GW00000438Courtesy of VOLKSWAGEN UNITED STATES, INC.

After completing repairs always:

scientia non olet · About LEMON Manuals