Crankshaft oil seal (pulley end), replacing: Installing

WARNING: This page is about a different car, the 1999 Volkswagen Jetta, 1998 Volkswagen Jetta, 1997 Volkswagen Jetta, 1996 Volkswagen Passat, and 1996 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Use engine oil to lightly oil lip of seal (do not use grease!)
Place guide sleeve from 3083 arbor onto crankshaft journal.
Slide oil seal over guide sleeve.

Fig 1: Placing Guide Sleeve From Arbor Onto Crankshaft Journal
Press in oil seal up to stop using sleeve from 3083.
Install and tension toothed belt.
- Engine code 1Z TOOTHED BELT, REMOVING AND INSTALLING (ENGINE CODE AAZ 09.94 and up)
- Engine code AHU TOOTHED BELT, REMOVING AND INSTALLING (ENGINE CODES AAZ UP TO 10.94, 1Z, AHU)
Fig 2: Pressing In Crankshaft Front Oil Seal