Muffler with mountings: Notes

1 - From catalytic converter 

2 - Double clamp 

• Observe installed position. Refer to Checking installation position of double clamp 

3 - 25 Nm 

4 - Mounting 

• Observe installed position. Refer to Checking installation position of double clamp  , Installation position of mounting 

5 - Forward muffler 

• Aligning. Refer to Separating point on exhaust pipe  and Muffler with mountings 

6 - Separating point 

• For repairing
• As standard, pre-exhaust pipe and rear mufflers are installed as a single component. For repairs, front exhaust pipe and rear muffler are supplied individually with a double clamp for connecting together.
• Cut through connecting pipe with body saw, e.g. V.A.G 1523, at right angles at separating point. Refer to Separating point on exhaust pipe 

7 - 20 Nm 

8 - Mounting 

9 - Muffler 

10 - Mounting 

• With retaining ring

11 - Tunnel bridge 

12 - 40 Nm