Diagnostic Trouble Code (DTC) memory, erasing and ending output
NOTE:
All functions which could previously be performed with V.A.G 1551 can also be performed with the tester VAS 5051.
Test requirements:
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC), memory .
1. Erasing DTC memory
- Press → key.
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press keys -0- and -5-; 05 enters "Erase DTC memory" function.
Indicated on display
| Rapid data transfer Q 05 - Erase DTC memory |
- Confirm entry with Q key
Indicated on display
| Rapid data transfer → DTC memory is erased! |
- Press → key.
Indicated on display
| Rapid data transfer HELP Select function XX |
Indicated on display
| Warning! DTC memory was not interrogated. |
NOTE:
Adhere exactly to test sequence: First check DTC memory, then erase
2. Ending output
- Press keys -0- and -6-, to end output.
Indicated on display
| Rapid data transfer Q 06 - End output |
- Confirm input with Q key.
Indicated on display
| Rapid data transfer HELP Select function XX |
- Switch ignition off.
- Disconnect V.A.G 1551 Scan Tool at Data Link Connector (DLC).
- Switch ignition on.
ABS warning light -K47- and warning light for brake system -K118- must go out after approx. 2 seconds.