Parts of EVAP canister system (vehicles with engine code AFP), removing and installing
WARNING: This page is about a different variant/trim than selected.
1 - Seal
- replace if damaged
2 - Ventilation line
- black
- Check for secure fitting
- To disengage, squeeze together at front
- from change-over valve. Refer to Fuel tank with attachments and fuel filter (vehicles with engine code AFP and BDF), removing and installing , item 11
3 - Ventilation line
- white
- Check for secure fitting
- To disengage, squeeze together at front
- from pressure retaining valve. Refer to Fuel tank with attachments and fuel filter (vehicles with engine code AFP and BDF), removing and installing , item 7
4 - Mounting screw
5 - Connection hose
- Pressure side
- Check for secure fitting
6 - Connector
- black, 3-pin
- for Leak Detection Pump (LDP) -V144-
7 - Vacuum line
- to upper part of intake manifold. Refer to Overview plan of EVAP canister system (vehicles with engine code AFP) , item 4
8 - Leak Detection Pump (LDP) -V144-*
- Under wheel housing liner in rear right wheel housing
- checking. Refer to Leak Detection Pump (LDP), checking
9 - Air filter for diagnostic pump
10 - Connection hose
- Intake side
- Check for secure fitting
11 - Bracket
12 - 10 Nm
13 - EVAP canister
- Under wheel housing liner in rear right wheel housing