Front brakes, 2FN brake caliper, Servicing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- When carrying out repairs install all parts supplied in repair kit.
- New brake calipers are filled with brake fluid and are pre-bled.
- Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
1 - Dust cap
- Push onto bleeder valve
2 - Bleeder valve
- Apply thin coat of assembly paste G 052 150 A2 to threads before screwing in
3 - Cap
- Insert in mounting bushing
4 - Guide pin, 25 Nm
5 - Mounting bushing
- Insert into brake caliper housing
6 - Brake caliper housing
7 - Brake carrier
- Install on brake caliper housing
8 - Retaining spring
9 - Seal
- Removing and installing. Refer to Front caliper piston, removing and installing
10 - Piston
- Removing and installing. Refer to Front caliper piston, removing and installing
- Apply thin coat of assembly paste G 052 150 A2 to piston before inserting
11 - Protective seal
- Removing and installing. Refer to Front caliper piston, removing and installing
- Do not damage when inserting piston