Steering angle sensor -G85-, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
- Turn wheels to straight ahead position.
- Removing airbag module and steering wheel.
Refer to AIRBAG
- Remove lower stowage compartment.
- Take out covering in footwell.
- Remove bolts -1-.
- Take off handle for height and reach adjustment -5-.
- Remove bolts -2-, -3- and -4-.
- Take off lower steering column switch trim.
- Take off upper steering column switch trim -1-.
The steering angle sensor -G85- is installed in a housing -1- together with the coil connector.
- Disconnect connectors -1- and -2-.
- Carefully lift locking lugs (arrows) and pull off steering angle sensor -G85-.
Installing
The steering angle sensor -G85- must be in its centered position before installing.
- Install steering angle sensor -G85- until lugs engage.
- Remove transportation protection.
- A yellow mark must be visible in hole (arrow -1-).
- The marks (arrows) must also align.
Make sure it does not move from centered position.
Further installation in reverse order
- Installing airbag module and steering column.
Refer to AIRBAG
- Perform steering angle sensor -G85- basic settings.
- Connecting VAS 5051 and selecting functions. Refer to VAS 5051 Vehicle Diagnostic, Testing and Information System, connecting and selecting functions