Brake pad wear indicator light -K32-
WARNING: This page is about a different variant/trim than selected.
- If the Brake pad wear indicator light -K32- -1- does not go out after ignition is switched on and test sequence is completed, or it lights up while driving, then the malfunction may be:
-a- The brake pads may be worn out
Check the front and rear brake pads.
Refer to Front brakes
Refer to Rear wheel brakes (disc brakes - front wheel drive), assembly overview
Refer to ABS system components for front and rear axles, removing and installing
-b- There is a malfunction in the activation of the brake pad wear indicator light -K32-.
Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations
For vehicles with display in instrument panel, it is indicated on display: "CHECK BRAKE PADS"