ABS system components on front axle, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removing and installing ABS system parts is identical for FS III and FN 3 brake calipers.
1 - ABS speed sensor
- Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
- Checked by On Board Diagnostic (OBD)
- Refer to Removing and installing speed sensor on front axle
2 - Wheel bearing housing
3 - Hex socket head bolt, 8 Nm (70 in lb)
4 - Splash plate
5 - Hex bolt, 10 Nm (62 in. lb)
6 - Wheel bearing
- Replace each time after removing
- Pressing out and in
Refer to FRONT SUSPENSION, SERVICING
7 - Phillips-head screw
8 - Brake disc
9 - Wheel hub with rotor
- Pressing out and in
Refer to FRONT SUSPENSION, SERVICING
10 - Circlip