ABS system components for rear axle, (Front wheel drive) removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
1 - ABS speed sensor
- Checked by On Board Diagnostic (OBD)
- Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
- Disc brakes. Refer to ABS system components for rear axle, (Front wheel drive) removing and installing
2 - Hex socket head bolt, 8 Nm (71 in lb)
3 - Stub axle
4 - Splash plate
5 - Wheel hub with wheel bearing and rotor
- Replace each time after removing
- Only replace complete
- Removing and installing
Refer to WHEEL BEARING/WHEEL HUB ON VEHICLES WITH DISC BRAKES, REMOVING AND INSTALLING
6 - Self-locking 12-point nut, 175 Nm (129 ft. lb)
- Always replace
7 - Cap
- Pressing off and driving in
Refer to 40 FRONT SUSPENSION
8 - Brake disc
9 - Phillips-head screw
10 - Hex bolt 60 Nm (44 ft. lb)
- With dished spring
11 - Brake drum (not used)
- Brake drum diameter 230 mm (9.06 in.)
- Wear limit 231 mm (9.09 in.)
- Release adjustment before removing brake drum
- Clean thoroughly, check for wear, damage, tolerances, damaged wheel bolt threads and perfect braking surface
12 - Back plate with brake shoes
13 - Axle beam