Removing and installing drive flange
WARNING: This page is about a different variant/trim than selected.
Removing
- Mount puller 3109 and remove circlip.
- Pull off drive flange with VW 391.
Installing
- Insert drive flange, dished washer and circlip.
- Pull drive flange in with 3109.
NOTE:
Drive flange can also be pulled in with VW 391.
Vehicles with triple roller axle shafts
- Bolt puller Kukko 18-0 to flange using two 8x35 mm bolts and 8 mm diameter washers.
- Pull off drive flange.