Adjustments to be completed after replacing individual components
WARNING: This page is about a different variant/trim than selected.
- When working on the transmission the following components only require adjustment if individual components have been replaced that directly affect the final drive adjustment. To eliminate unnecessary adjustments observe following:
| To adjust | |||
| Components being replaced | Differential housing with riveted gear wheel Refer to Differential, adjusting |
Adjusting input gear1) . Refer to Input gear, adjusting |
Adjusting drive pinion with output gear1) Refer to Drive pinion, adjusting |
| Transmission housing | X | X | X |
| Input gear1) | X | X | |
| Input gear tapered roller bearing | X | ||
| Output gear1) | X | X | |
| Drive pinion | X | ||
| Drive pinion tapered roller bearing | X | ||
| Differential cage with gear wheel | X | ||
| Tapered roller bearing for differential, bearing body or shim | X | ||
| Supporting ring, park lock gear or bearing cover | X |
1) Always replace input gear and output gear together