Start diagnosis
WARNING: This page is about a different variant/trim than selected.
- Switch the ignition on.
- Depress the brake pedal and maintain depressed.
- Shift the selector lever into all positions.
The selector lever position must correspond to the display of the Control Module with the indicator unit in the Instrument Cluster Control Module J285.
- Switch the ignition off.
If the selector lever position does not correspond to the display of the Control Module with indicator unit in the Instrument Cluster Control Module J285:
- Disconnect the Multi-Function Transmission Range (TR) Switch F125 electrical harness connector - 2 - .
- Check the electrical harness connector for damage, corrosion, loose or broken terminals.
- Repair any damage found to the electrical harness connector.
If the electrical harness connector is not OK:
- Repair the malfunction.
If the electrical harness connector is OK: