II - Reverse gear clutch -K2- to large sun gear, removing and installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Refer to Overview, Planetary gearbox, disassembling and assembling -Overview- .
- Disassembling planetary gearbox. Refer to Planetary gearbox, disassembling and assembling .
- Assembling. Refer to Assembling planetary gearbox .
1 - Reverse gear clutch -K2-
- Disassembling and assembling. Refer to Reverse gear clutch -K2-, disassembling and assembling
2 - Shim
- Determining thickness. Refer to Adjusting clutch play between -K1- and -K2-, Clutch play between -K1- and -K2-, adjusting
- 1 or 2 shims can be installed
3 - 1st to 3rd gear clutch -K1-
- Spare part is determined according to transmission code letters
- Clutches -K1- and -K3- are pressed together
- Disassembling and assembling. Refer to 1st to 3rd gear clutch -K1-, disassembling and assembling
4 - Seal
- Always replace
- To replace press -K1- off -K3-. Refer to Pressing clutch -K1- off -K3-
5 - 3rd and 4th gear clutch -K3- with turbine shaft
- Spare part is determined according to transmission code letters
- Disassembling and assembling. Refer to 3rd and 4th gear clutch -K3- with turbine shaft, disassembling and assembling
- Clutches -K1- and -K3- are pressed together
- Two different types. Refer to Torque converter, servicing
6 - 1st to 3rd gear clutch -K1- with 3rd and 4th gear clutch -K3-
- Clutches -K1- and -K3- are pressed together
- Pressing -K1- off -K3-. Refer to Pressing clutch -K1- off -K3-
- Pressing -K1- onto -K3-. Refer to Pressing clutch -K1- onto -K3-
7 - Axial needle bearing with washer
- Axial needle bearing faces small input shaft
8 - Small input shaft
9 - Needle bearing
10 - Axial needle bearing
11 - Large input shaft
12 - Axial needle bearing
13 - Axial needle bearing washer
- With shoulder
14 - Large sun wheel
15 - Axial needle bearing
16 - Axial needle bearing washer
17 - Transmission housing with freewheel and circlips installed