Work sequence
WARNING: This page is about a different variant/trim than selected.
- Connect vehicle diagnostic, testing and information system VAS 5051 using diagnostic cable VAS 5051/1 or diagnostic cable VAS 5051/3 as follows:
- Connect diagnostic cable harness connector to Data Link Connector (DLC).
- Depending upon desired function, switch ignition on or start engine → table.
NOTE:
- In "Basic Setting" function 04 through "Read Measuring Value Block" function 08, the display fields will be listed from top to bottom.
- If the display does not indicate what is described in the test sequence: VAS 5051 vehicle diagnostic, testing and information system operating instructions