Work sequence
WARNING: This page is about a different variant/trim than selected.
NOTE:
- All functions which could previously be performed with V.A.G 1551/1552 can also be performed with Scan Tool VAS 5051.
- Connect Scan Tool (ST) V.A.G 1551 (V.A.G 1552) and with "Address word" 01 select ECM (with engine idling), Scan Tool, connecting → Scan Tool V.A.G 1551 , connecting .)
Only when engine does not start:
- Turn on ignition.
- Switch on Scan Tool printer with print button. Indicator lamp in button must illuminate.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Operate Scan Tool (ST) and follow information on display:
- Press buttons - 0 - and - 2 - for function "Check DTC memory" and confirm entry with - Q - button.
Number of DTC stored or "No DTC recognized!" will be as shown.
| X DTCs recognized! |
If no DTC is stored:
- Press → button.
If one or more DTC are stored:
Stored DTCs will be displayed and printed out one after another.
After stored DTCs have been printed out, display will appear as shown
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 5 - for function "Erase DTC memory" and confirm entry with - Q - button.
Indicated on display:
| Rapid data transfer -> DTC memory is erased! |
NOTE:
- If ignition is turned off between "Check DTC memory" and "Erase DTC memory" DTC memory will not be erased.
- Set readiness code → Readiness code, setting , if DTC memory was erased.
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 6 - for "End output" and confirm with - Q - button.
- Correct DTCs on print-out using DTC table: V.A.G codes → DTC table: V.A.G codes , SAE P codes → Diagnostic Trouble Code (DTC) table: SAE P codes